PROPERTIES OF STEEL-POLYPROPILENE HYBRID FIBERS REINFORCED CONCRETE

Nenad Ristić, Dušan Grdić, Jelena Bijelić, Zoran Grdić, Gordana Topličić-Ćurčić

DOI Number
-
First page
235
Last page
244

Abstract


This paper present the results of mechanical properties of hybrid reinforced concrete made by adding polypropylene and steel fibers into concrete mixture. For the testing purposes were used steel fibers with hooked ends and monofilament polypropylene fibers. The total of 5 batches of concrete were made: concrete with addition of steel fibers, polypropylene fibers and their combination in amount of 0,5 % of the concrete volume. The test results show that concretes made by adding of 0.4% steel and 0.1% polypropylene fibers have better performance compared to other concretes.

Full Text:

PDF

References


H.R. Pakravan, M. Latifi and M. Jamshidi, “Hybrid short fiber reinforcement system in concrete: A review”, Construction and building materials, vol. 142, pp. 280-294, 2017.

N. Banthia and R. Gupta, “Hybrid fiber reinforced concrete (HyFRC): fiber synergy in high strength matrices”, Mater. Struct. vol. 37 (10), pp. 707–716, 2004

W. Yao, J. Li, K. Wu „Mechanical properties of hybrid fiber-reinforced concrete at low fiber volume fraction“, Cement and Concrete Research, vol. 33, pp. 27-30, 2003.

X. Guan, X. Liu, X. Jia, Y. Yuan, J. Cui, and H. A. Mang, „A stochastic multiscale model for predicting mechanical properties of fiber reinforced concrete“, International Journal of Solids and Structures. Vol. 56-57, pp. 280-289, 2105.

E.R. Silva, J.F.J. Coelho and J.C. Bordado, „Strength improvement of mortar composites reinforced with newly hybrid-blended fibres: influence of fibres geometry and morphology“, Construction and building materials, vol 40, pp. 473–480, 2013.

S.F.U. Ahmed and M. Maalej, „Tensile strain hardening behaviour of hybrid steelpolyethylene fibre reinforced cementitious composites“, Construction and building materials, vol. 3, pp. 96–106, 2003.

A. Bentur and S. Mindess, „Fibre Reinforced Cementitious Composites“, E &FN Spon, 1990.

C.X.Qiana and P. Stroevenb, “Development of hybrid polypropylene-steel fibre-reinforced concrete”, Cement and concrete research, vol. 30, pp. 63-69, 2000.

P. S. Song, J. C. Wu, S. Hwang and B. C. Sheu, „ Statistical analysis of impact strength and strength reliability of steel–polypropylene hybrid fiber-reinforced concrete”, Construction and Building Materials, vol. 19, pp. 1-9, 2005.

A. Sivakumur and M. Santhanam, „Mechanical properties of high strength concrete reinforced with metalic and non-metalic fibres“, Cement&Concrete Composites, vol. 29, pp. 603-608, 2007.

N. Štimer and V. Ukrainczyk, „Model nadsloja industrijskog poda od udarnim opterećenjem“, Zbornik radova sa 12. Slovenskog kolokvija o betonima „Novosti pri gradnji tlakov“, IRMA, Ljubljana, pp. 49-63, 2005.


Refbacks

  • There are currently no refbacks.


ISSN 0354-4605 (Print)

ISSN 2406-0860 (Online)