IMPACT OF TROMBE WALL CONSTRUCTION ON THERMAL COMFORT AND BUILDING ENERGY CONSUMPTION

Dusan J. Randjelovic, Miomir Vasov, Marko Ignjatovic, Ivana Bogdanovic Protic, Dragan Kostic

DOI Number
10.2298/FUACE180302008R
First page
279
Last page
292

Abstract


Energy consumption has reached its highest level globally. Buildings have the largest share in total energy consumption, so we must take into account their functioning and the consequences that can arise. Passive solar design is an imperative in modern architecture, and Trombe wall, as one of the principles of this design, is certainly distinguished. The paper presents an overview of the characteristics of the construction of the Trombe Wall in order to improve thermal stability and reduce energy consumption in buildings. Starting from the consideration of climatic influencing factors, through the heat capacity of the materials applied and their thickness and color of the thermal mass, it is very important to know in detail all the factors that can lead to the improvement of the efficiency of this system. The specific heat of the walls in the building, the time delay, the decrement factor and the influence and position of the thermal insulation were also taken into account. The effect of glazing as well as the influence of the ventilation openings were highlighted as significant elements. On the basis of the analysis of the above components, the conclusions and guidelines for designing this type of constructions were made in order to improve the efficiency and reduced energy consumption while providing adequate comfort in the facility.


Keywords

Climate conditions, Heat accumulating materials, Insulation, Glazing, Ventilation, Final Energy Use

Full Text:

PDF

References


V Bogdanović and I Bogdanović Protić. Effects of town planing conditions, structural performances and regulations on thermal loss of buildings. 45th Int. Congr. Exhib. Heating, Refrig. air Cond., Belgrade, Serbia: The Serbian Society for Heating, Refrigerating and Air-Conditioning within the Union of Mechanical and Electrical Engineers and Technicians of Serbia; , p. 1–6.

HH Ali and SF Al Nsairat. “Developing a green building assessment tool for developing countries – Case of Jordan.” , Build Environ vol. 44, :pp. 1053–64:2009. doi:10.1016/j.buildenv.2008.07.015.

M Nikоlić, A Мilојkоvić, D Stanković, V Bogdanović, and I Mijailović. “Implementation models for energy recovery measures of existing kindergarten facilities in Serbia.” , Teh Vjesn Gaz vol. 23, :2015.

Ž Koški and G Zorić. “Solar energy accumulation in family passive houses.” , Elektron Časopis Građevinskog Fak Osijek vol. 1, :pp. 80–92:2010. doi:10.13167/2010.1.8.

W O’Brien, T Kesik, and A Athienitis. Solar design days: A tool for passive solar house design. ASHRAE Trans., vol. 120, Amer. Soc. Heating, Ref. Air-Conditoning Eng. Inc.; , p. 101–13.

“Trombe Walls:”n.d. http://www.designbuilder.co.uk/helpv4.2/Content/Trombe_Walls.htm.

O Saadatian, K Sopian, CH Lim, N Asim, and MY Sulaiman. “Trombe walls: A review of opportunities and challenges in research and development.” , Renew Sustain Energy Rev vol. 16, :pp. 6340–51:2012. doi:10.1016/j.rser.2012.06.032.

S Jaber and S Ajib. “Optimum design of Trombe wall system in mediterranean region.” , Sol Energy vol. 85, :pp. 1891–8:2011. doi:10.1016/j.solener.2011.04.025.

A Fares. “The Effect of Changing Trombe Wall Component on the Thermal Load.” , Energy Procedia vol. 19, :pp. 47–54:2012. doi:10.1016/j.egypro.2012.05.181.

B J Douglas, R W Jones, USD of Energy, O of SA for Buildings., USD of EP and HSE Division., I Total Environmental Action, et al. Passive solar design handbook. Print book. Washington D.C.; Springfield VA: The Office ;[Supt. of Docs. U.S. G.P.O. distributor] ;;Available from National Technical Information Service; .

M Vasov, D Ranđelović, V Bogdanović, M Ignjatović, and J Stevanović. Improving Thermal Stability and Reduction of Energy Consumption in Serbia by Implementing Trombe Wall Construction. In: Laković Paunović M, Stojiljković M, editors. 18th Symp. Therm. Sci. Eng. Serbia, University of Niš, Faculty of Mechanical Engineering in Niš; , p. 59–68.

M Bojić, K Johannes, and F Kuznik. “Optimizing energy and environmental performance of passive Trombe wall.” , Energy Build vol. 70, :pp. 279–86:2014. doi:10.1016/j.enbuild.2013.11.062.

KJ Kontoleon and E a. Eumorfopoulou. “The influence of wall orientation and exterior surface solar absorptivity on time lag and decrement factor in the Greek region.” , Renew Energy vol. 33, :pp. 1652–64:2008. doi:10.1016/j.renene.2007.09.008.

“ISO 13790:2008(en), Energy performance of buildings — Calculation of energy use for space heating and cooling:”n.d. https://www.iso.org/obp/ui/#iso:std:iso:13790:ed-2:v1:en.

S a. Al-Sanea, MF Zedan, and SN Al-Hussain. “Effect of thermal mass on performance of insulated building walls and the concept of energy savings potential.” , Appl Energy vol. 89, :pp. 430–42:2012. doi:10.1016/j.apenergy.2011.08.009.

B Andjelkovic, B Stojanovic, M Stojiljkovic, J Janevski, and M Stojanovic. “Thermal mass impact on energy performance of a low, medium and heavy mass building in Belgrade.” , Therm Sci vol. 16, :pp. 447–59:2012. doi:10.2298/TSCI120409182A.

G. Florides, S. Tassou, S. Kalogirou, and L. Wrobel. “Measures used to lower building energy consumption and their cost effectiveness.” , Appl Energy vol. 73, :pp. 299–328:2002. doi:10.1016/S0306-2619(02)00119-8.

A Jeanjean, R Olives, and X Py. “Selection criteria of thermal mass materials for low-energy building construction applied to conventional and alternative materials.” , Energy Build vol. 63, :pp. 36–48:2013. doi:10.1016/j.enbuild.2013.03.047.

P Ma and L-S Wang. “Effective heat capacity of interior planar thermal mass (iPTM) subject to periodic heating and cooling.” , Energy Build vol. 47, :pp. 44–52:2012. doi:10.1016/j.enbuild.2011.11.020.

V Šimetin. Građevinska fizika. Zagreb: Fakultet građevinskih znanosti Sveučilišta u Zagrebu, 1983; .

F Abbassi, N Dimassi, and L Dehmani. “Energetic study of a Trombe wall system under different Tunisian building configurations.” , Energy Build vol. 80, :pp. 302–8:2014. doi:10.1016/j.enbuild.2014.05.036.

G Gan. “A parametric study of Trombe walls for passive cooling of buildings.” , Energy Build vol. 27, :pp. 37–43:1998.

R Zeng, X Wang, H Di, F Jiang, and Y Zhang. “New concepts and approach for developing energy efficient buildings: Ideal specific heat for building internal thermal mass.” , Energy Build vol. 43, :pp. 1081–90:2011. doi:10.1016/j.enbuild.2010.08.035.

C a. Balaras. “The role of thermal mass on the cooling load of buildings. An overview of computational methods.” , Energy Build vol. 24, :pp. 1–10:1996. doi:10.1016/0378-7788(95)00956-6.

H Asan. “Numerical computation of time lags and decrement factors for different building materials.” , Build Environ vol. 41, :pp. 615–20:2006. doi:10.1016/j.buildenv.2005.02.020.

J Savić, D Đurić-Mijović, and V Bogdanović. “Architectural glass: types, performance and legislation.” , Facta Univ Ser Archit Civ Eng vol. 11, :pp. 1–12:2013.

F Stazi, A Mastrucci, and C Di Perna. “The behaviour of solar walls in residential buildings with different insulation levels: An experimental and numerical study.” , Energy Build vol. 47, :pp. 217–29:2011. doi:10.1016/j.enbuild.2011.11.039.

Y Liu, D Wang, C Ma, and J Liu. “A numerical and experimental analysis of the air vent management and heat storage characteristics of a trombe wall.” , Sol Energy vol. 91, :pp. 1–10:2013. doi:10.1016/j.solener.2013.01.016.

S Dragicevic and M Lambic. “Numerical study of a modified Trombe wall solar collector system.” , Therm Sci vol. 13, :pp. 195–204:2009. doi:10.2298/TSCI0901195D.

M Todorović, M Bogner, and N Denić. O izolaciji. ETA, MilanaRakića 4 11000 Beograd www.eta-beograd.rs; .


Refbacks

  • There are currently no refbacks.


ISSN 0354-4605 (Print)
ISSN 2406-0860 (Online)
COBISS.SR-ID 98807559