A NUMERICAL AND EXPERIMENTAL ANALYSIS OF THE DYNAMIC STABILITY OF HYDRAULIC EXCAVATORS

Dragoslav Janošević, Jovan Pavlović, Vesna Jovanović, Goran Petrović

DOI Number
https://doi.org/10.22190/FUME180404015J
First page
157
Last page
170

Abstract


The paper presents the results of a numerical and experimental analysis of the dynamic stability of hydraulic excavators. The analysis has employed the software developed on the basis of a defined general dynamic mathematical model of an excavator grounded in Newton-Euler equations as well as the measured quantities of the excavator operating state in exploitation conditions. The defined model is used to model the members of the excavator kinematic chain using rigid bodies while the actuators (hydraulic cylinders and hydraulic motors) of the excavator drive mechanisms are modeled with elastically dampened elements. The elastically dampened characteristics of the actuators are defined with regard to the size of the actuator as well as to the compressibility and temperature of the hydraulic oil used in the excavator hydrostatic drive system. To illustrate the analysis, the paper provides the results of the analysis of the dynamic stability of a 16000 kg tracked excavator equipped with a manipulator digging bucket of 0.6 m3 in capacity.

Keywords

Hydraulic Excavators, Dynamic Stability, Oil Temperature, Modeling

Full Text:

PDF

References


Nikolaevich, B.E., Nyrgaiazovich, B.I, Sergeevich Z.S., 2015, Enhancing the Stability of the Timber Harvesting Machine of Manipulator Type by Using an Active Suspension System, Journal of Applied Engineering Science, 13(2), pp. 111-116.

Ghasempoor, A., Sepehri, N., 1998, A Measure of Stability for Mobile Manipulators with Application to Heavy-Duty Hydraulic Machines, Journal of Dynamic Systems, Measurement and Control, 120(3), pp. 360-370.

Abo-Shanab, R.F., Sepehri, N., 2004, Tip-Over Stability of Manipulator-Like Mobile Hydraulic Machines, Journal of Dynamic Systems, Measurement and Control, 127(2), pp. 295-301.

Grigorov, B., Mitev, R., 2017, Dynamic behavior of a hydraulic crane operating a freely suspended paylood, Journal of Zhejiang University-SCIENCE A, 18(4), pp. 268-281.

Koivo, A. J., Thoma, M., Kocaoglan E., Andrade-Cetto, J., 1996, Modeling and Control of Excavator Dynamics during Digging Operation, Journal of Aerospace Engineering, 9(1), pp 10-18.

Dong, R., Pan, C., Hartsell, J., Welcome, D., Lutz, T., Brumfield, A., Harris, J., Wu, J., Wimer, B., Mucino V., Means, K., 2012, An Investigation on the Dynamic Stability of Scissor Lift, Open Journal of Safety Science and Technology, 2(1), pp. 8-15.

Mitrev, R., Janošević, D., Marinković, D., 2017, Dynamical Modelling of Hydraulic Excavator Considered as a Multibody System, Tehnicki Vjesnik (Technical Gazette), 24(Suppl. 2), pp. 327-338.

Jovanović, V., Janošević, D., Marinković, D., 2015, Determination of the Load Acting on the Axial Bearing of a Slewing Platform Drive in Hydraulic Excavators, Acta Polytechnica Hungarica, 12(1), pp. 5-22.

Dresig, H., Holzweißig, F., 2010, Dynamics of Machinery, Springer-Verlag Berlin Heidelberg.

Ewald, R., Hutter, J., Kretz, D., Liedhegener, F., Schenkel, W., Schmitt, A., Reik M., 1986, Proportional and Servo Valve Technology - Hydraulic trainer Vol. 2, Manesmann Rexroth.

Janošević, D., Jovanović, V., 2016, Synthesis of the drive mechanisms of a hydraulic excavator, Monograph, University of Niš, Faculty of Mechanical Engineering.

Muvenge, O.M., 2008, Simulation of the Dynamic Behavior of an Excavator due to Interacting Mechanical and Hydraulic Dynamics, Master thesis, Jomo Kenyatta University of Agriculture and Technology.

Fox, B., Jennings, L.S., Zomaya, A.Y., 2002, On the modeling of actuator dynamics and the computation of prescribed trajectories, Computers & Structures, 80(7-8), pp. 605-614.




DOI: https://doi.org/10.22190/FUME180404015J

Refbacks

  • There are currently no refbacks.


ISSN: 0354-2025 (Print)

ISSN: 2335-0164 (Online)

COBISS.SR-ID 98732551

ZDB-ID: 2766459-4