EXPERIMENTAL DETERMINATION OF BEARING LOADS IN ROTATING PLATFORM DRIVE MECHANISMS OF HYDRAULIC EXCAVATORS

Vesna Jovanović, Dragoslav Janošević, Nikola Petrović

DOI Number
-
First page
157
Last page
169

Abstract


The paper presents a procedure for experimental determination of slewing bearing loads in the rotating platform drive mechanisms of hydraulic excavators with an excavating manipulator. A mathematical model is defined which enables the determination of the vectors of force and moment of bearing loads, on the basis of the measured quantities of the state of an excavator in operation under exploitation conditions. The measured quantities of the state of an excavator relate to the position of the kinematic chain and pressures of the hydrostatic system in the actuator ducts of the excavator drive mechanisms. As an example, the paper provides the research results obtained in the experimental determination of slewing bearing loads in the rotating platform drive mechanism of a hydraulic excavator with the mass of 16t.

Full Text:

PDF

References


Janošević, D., Mitrev R., Andjelković B., Petrov P., 2013, Quantitative measures for assessment of the hydraulic excavator digging efficiency, Journal of Zhejiang University-SCIENCE A (Applied Physics & Engineering), 13(12), pp. 926-942.

Tomović, R., Miltenović, V., 2008, Impact of rolling bearing structural parameters on the balanced rigid rotor’s oscillation frequency, Facta Universitatis Series: Mechanical Engineering 6(1), pp. 57- 66.

Jovanović, V., Janošević, D., Petrović, N., 2013, Analysis of axial bearing load of a rotating platform drive in hydraulic excavators, Tehnički vjesnik/Technical Gazette, 2(21), pp. 263-270.

Jin, K., Park, T., Lee, H., 2012, Control method to suppress the swing vibration of a hybrid excavator using sliding mode approach, Journal of Mechanical Engineering Science, 1, pp. 1237-1253.

Jin, Z., 2011, Analysis on dynamic characteristics of closed slewing system for large-scale hydraulic excavator, Fluid Power and Mechatronics (FPM), International Conference, pp. 663-668.

Pavlović, J., Jovanović, M., Milojević, A., 2014, Optimal synthesis of a manipulator using two competitive methods, Facta Universitatis Series: Mechanical Engineering 12(1), pp. 61-72.

Janošević, D., Petrović, N., Nikolić, V., 2010, Mechanism synthesis of manipulator of mobile machines, Machine Design, Faculty of Technical Sciences Novi Sad, pp. 55-58.

Janošević, D., 1997, Optimalna sinteza pogonskih mehanizama hidrauličkih bagera, doktorska disertacija, Mašinski fakultet Univerziteta u Nišu.

Janošević, D., 2006, Projektovanje mobilnih mašina, Univerzitet u Nišu, Mašinski fakultet.

Slewing Bearings, 2007, Rothe Erde GmbH, Dortmund.


Refbacks

  • There are currently no refbacks.


ISSN: 0354-2025 (Print)

ISSN: 2335-0164 (Online)

COBISS.SR-ID 98732551

ZDB-ID: 2766459-4