Cover Image

ELECTROPHORETIC DEPOSITION AS AN EFFECTIVE AND SIMPLE PROCESSING TECHNIQUE FOR FABRICATION OF MAGNESIUM SILICATE HYDRATE (M-S-H) COATINGS ONTO STAINLESS STEEL SUBSTRATES

Jelena Čović, Marjan Ranđelović, Aleksandra Zarubica, Aleksandar Bojić

DOI Number
10.2298/FUPCT1803297R
First page
297
Last page
308

Abstract


Magnesium silicate hydrate (M-S-H) was prepared via one-pot hydrothermal synthesis and electrophoretically deposited (EPD) onto stainless steel substrate (Type 304), varying different process parameters. The optimal conditions for the EPD process were found to be as follows. A stable suspension of material was achieved using isopropanol containing 1% water as dispersing medium and Mg-nitrate as charging additive. The best coating was obtained after three successively repeated EPD processes at a voltage of 30 V, accompanied by drying at room temperature between each EPD cycle. The coating showed a thickness of 31 µm and very smooth surface. After calcination at 900 °C coating retains its adherence to the substrate but undergoes a structural transformation from poorly crystallized M-S-H to well-crystallized clinoenstatite phase which is known for its biocompatibility. As a result, it densifies and shrinks giving grainy and slightly rough surface. Structural properties and parameters of the magnesium silicate hydrate (M-S-H) and clinoenstatite were acquired by XRD technique, while morphology was examined by the analysis of SEM micrographs. This study demonstrates that: i) M-S-H can be synthesized through simple hydrothermal route starting from simple, low-cost precursors, ii) EPD process is an effective technique for deposition of M-S-H materials onto stainless steel and iii) inosilicate mineral (clinoenstatite) can be successfully obtained from M-S-H by calcination at 900 °C.

 

HIGHLIGHTS

  • Magnesium silicate hydrate (M-S-H) was prepared via a one-pot hydrothermal synthesis.
  • The optimal conditions for the electrolytic deposition process were determined.
  • Kinetics of the process were investigated using the Hamaker`s equation.
  • Clinoenstatite can be successfully obtained from M-S-H by calcination.

Keywords

electrophoretic deposition, clinoenstatite, magnesium silicate hydrate, hydrothermal

Full Text:

PDF

References


Bernard, E., Lothenbach, B., Rentsch, D., Pochard, I., Dauzères, A., 2017. Phys. Chem. Earth, 99, 142-157.

Besra, L., Liu, M., 2007. Prog. Mater. Sci. 52, 1-61.

Bobruk, M., Molin, S., Chen, M., Brylewski, T., Hendriksen, P.V., 2018. Mater. Lett. 213, 394-398.

Boccaccini, A.R., Keim, S., Ma, R., Li, Y., Zhitomirsky, I., 2010. J. R. Soc. Interface 7, S581–S613. doi: 10.1098/rsif.2010.0156.focus

Brew, D.R.M., Glasser, F.P., 2005. Cement Concrete Res. 35, 85-98.

Chu, P.K., Liu, X., 2008. Biomaterials Fabrication and Processing Handbook, CRC press

Curtis, V.R., Watson, F.T., 2008. Dental biomaterials, Imaging, testing and modelling, CRC press, Woodhead publishing limited

Diba, M., Goudouri, O-M., Tapia, F., Boccaccini, R.A., 2014. Curr. Opin. Solid St. M. 18(3) 147-167.

Farrokhi-Rad, M., 2018a. J. Alloy. Compd. 741, 211-222.

Farrokhi-Rad, M., 2018b. Ceram. Int. 44, 622-630.

Goudouri, O-M., Kontonasaki, E., Papadopoulou, L., Kantiranis, N., Lazaridis, N.K., Chrissafis, K., Chatzistavrou, X., Koidis, P., Paraskevopoulos, K.M., 2014. Mater. Chem. Phys. 145, 125-134.

Hench, L.L, Polak, J. M., 2002. Science 295 (5557) 1014-1017.

Lothenbach, B., Nied, D., Hôpital, E.L, Achiedo, G., Dauzères, A., 2015. Cement Concrete Res. 77, 60-68.

Mala, R., Ruby Celsia, A.S., 2018. Fundamental Biomaterials: Ceramics, 195-221.

Mohammadi, E., Aliofkhazraei, M., Sabour Rouhaghdam, A., 2018. Ceram. Int. 44, 1471-1482.

Nied, D., Enemark-Rasmussen, K., L`Hopital, E., Skibsted, J., Lothenbach, B., 2016. Cement Concrete Res. 79, 323-332.

Rojaee, R., Fathi, M., Raeissi, K., Taherian, M., 2014. Ceram. Int. 40, 7879-7888.

Roosz, C., Grangeon, S., Blanc, P., Montouillout, V., Lothenbach, B., Henocq, P., Giffaut, E., Vieillard, P., Gaboreau, S., 2015. Cement Concrete Res. 73, 228-237.

Sarkar, P., Nicholson, S.P., 1996. J. Am. Ceram. Soc. 79(8), 1987-2002.

Shehayeb, S., Deschanels, X., Karamé, I., Ghannam, L., Toquer, G., 2017. Surf. Coat. Tech. 322, 38-45.

Sorrell, C.C., Taib, H., Palmer, T.C., Peng, F., Xia, Z., Wei, M., 2011. Hydroxyapatite and Other Biomedical Coatings by Electrophoretic Deposition, Biological and Biomedical Coatings Handbook: Processing and Characterization, Sam Zhang, 81-137.

Tran, H.M., Scott, A., 2017. Constr. Build. Mater. 131, 526-535.

Wu, C., Chen, Z., Wu, Q., Yi, D., Friis, T., Zheng, X., Chang, J., Jiang, X., Xiao, Y., 2015. Biomaterials 71, 35-47.


Refbacks

  • There are currently no refbacks.


ISSN 0354-4656 (print)

ISSN 2406-0879 (online)